Planning A Border: THE BEST WAY of planning a border is to work with small groups of plants so you can concentrate on the relationship between the subjects, and so gradually build up the groups into a whole border planting. Choose plants with shapes that complement each other and which make an interesting and varied effect.
You will notice that different plants create a variety of effects. Spiky plants, for example, are active and lead the eye upward and onward to neighboring plants, while gentle hummock-forming plants are calming and bland, and lead the eye horizontally along the border.
At the same time think of height. Either use a tier system with tall plants at the back and shorter ones at the front, or use tall plants in the middle of the group to create peaks of interest, with shorter-growing plants leading the eye upward toward them. This will divert the eye and prevent it from traveling straight down the border, taking it all in at a glance. However, if tall plants are used toward the front of a border, they should be wispy enough to allow the eye to pass through them, yet substantial enough to break the line.
A border of mixed or herbaceous plants will provide flowers and foliage for cutting, and plants that can be left in position for a number of years. Apart from pruning and dividing, they demand little work. However, it has to be said that these benefits will only be reaped by those who put the initial work into the planning, designing and preparing. That might sound horrifying to the new gardener, but it can be a pleasure.See Also A Border Needs:A BORDER needs a certain amount of space to be effective. The minimum requirements are 4 x 12ft. If the border is any smaller than this you should restrict the number of plants used to six or seven different types, ensuring that they provide a good mix of flowers and foliage over a long period of the year.
Align the edge of the border with your ruled pencil guideline. When you are satisfied that the border paper is straight, brush it onto the wall. Until the paste dries, you can make minor adjustments to the position of the paper, if necessary. Just carefully lift a corner, peel back as much paper as you wish to reposition, and then brush it down in place once more. Don't overstretch the border paper at this stage. By tugging it, you may get a perfectly flush fit, only to find that it shrinks back slightly as it dries out. This will leave unsightly gaps that cannot then be rectified.
On The Other Hand See The Border Strip:The border strip technique entails dividing the land into long, rectangular sec¬tions fed by a common supply channel. Water ducted into this ditch flows as a broad sheet over the entire strip, the surplus draining off at the lower end. Border strips are most often used to grow small grains and fodder crops.
The cost of equipment is high, but is offset by savings in labor and production achieved, proportioning of the surface speeds of the sets of rolls is arranged by a system of ig gears.,eet and strip are cold rolled to desired ss to obtain desired finish, to attain certain inical properties, to make gages lighter than hot strip mill can produce economically, and ,uce sheet and strip of more uniform thick-There are many types of mills used for rolling; the wider and thinner the strip, the rigid the mill and the greater the power rement. For narrow strip, two-high mills be used; for wide strip, four-high mills arery.
|
